HP StorageWorks C-Series Fabric Switches for SAN-OS 3.3(3) and FabricWare 2.1(3) Release Notes (AA-RWEHT-TE, April 2009)

13 MDS Multilayer Director & Multilayer Fabric Switches Release Notes
FCIP Write Acceleration Feature Must Not Be Enabled When
Implementing Continuous Access Enterprise Virtual Array
Continuous Access Enterprise Virtual Array includes an FCIP write acceleration feature. For this
reason, Cisco’s FCIP write acceleration must not be enabled in a Continuous Access EVA
environment. By default Cisco SAN-OS write acceleration is disabled.
FCIP Tape Acceleration
SAN-OS FCIP Tape Acceleration (Write & Read) is disabled by default. Enabling FCIP Tape
Acceleration may cause a tape library to go offline with certain tape backup applications that
support shared tape library options. If this issue is encountered, disable the feature.
Note: FCIP Tape Read Acceleration can only be enabled when both ends of the FCIP tunnel are
running SAN-OS 3.0(1) or newer
Switch Settings for HP Continuous Access Enterprise Virtual
Arrays and HP Data Replication Manager for Modular Arrays
The default load balancing policy for SAN-OS is Src-ID/Dst-ID/OX-ID. This must be changed
when using Enterprise Virtual Array families or Modular Array families configured for
Continuous Access EVA and/or Data Replication Manager (DRM). Change the default load
balance setting to Src-ID/Dst-ID using either one of the following two procedures:
Note: The MDS 9020 only supports Src-ID/Dst-ID.
Using the Management Console or Telnet to Change the Load Balancing Setting
Use the following procedure to change the load balance setting to Src-ID/Dst-ID with
management console or telnet:
Note: Your login account must have network-admin privileges to complete this procedure.
1. Log into the switch using either the management console or telnet.
2. Enter your network-admin privileged account by entering your login name and password.
switch login: admin
Password: <admin password>
3. Enter the following to enter configuration mode:
switch# config terminal
4. Enter the following command to enter the VSAN database:
switch(config)# vsan database