Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.2(1a) (OL-19964-02, September 2009)
Send documentation comments to mdsfeedback-doc@cisco.com
14
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.2(1a)
OL-19964-02
Upgrading Your Cisco MDS NX-OS Software Image
Upgrading Your Cisco MDS NX-OS Software Image
This section lists the guidelines recommended for upgrading your Cisco MDS NX-OS software image
and includes the following topics:
• General Upgrading Guidelines, page 14
• Enabling Telnet Required After an Upgrade, page 19
• Upgrading Effect on VSAN 4079, page 19
• FICON Supported Releases and Upgrade Paths, page 17
• Upgrading with IVR Enabled, page 19
• Reconfiguring SSM Ports Before Upgrading to NX-OS Release 4.2(1a), page 20
• Upgrading the SSI Image on Your SSM, page 22
• Upgrading a Cisco MDS 9124 or Cisco MDS 9134 Switch, page 22
• Performing a Disruptive Upgrade on a Single Supervisor MDS Family Switch, page 23
• Resetting SNMP Notifications Following an Upgrade, page 23
Note Before you begin the upgrade process, review the list of chassis and modules that Cisco MDS NX-OS
Release 4.2(1a) supports. See the “MDS 9000 Chassis and Module Support in Cisco MDS NX-OS 4.x”
section on page 9.
For detailed instructions for performing a software upgrade using Cisco Fabric Manager, see the Cisco
Fabric Manager Release Notes for Release 4.2(1a), which is available from the following website:
http://www.cisco.com/en/US/partner/products/ps10495/prod_release_notes_list.html
General Upgrading Guidelines
Note To upgrade to NX-OS Release 4.2(1a) from SAN-OS Release 3.2(3a) or earlier, first upgrade to SAN-OS
Release 3.3(x) and then upgrade to NX-OS Release 4.2(1a).
Use the following guidelines when upgrading to Cisco MDS NX-OS Release 4.2(1a):