Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(8a) (OL-27554-05, May 16, 2013)

Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(8a)

OL-27554-05

Limitations and Restrictions

• Rate Mode: dedicated

• Buffer Credits: default value

When you configure port mode to auto or E for all ports in the global buffer pool, you need to reconfigure

buffer credits on one or more of the ports. The total number of buffer credits configured for all the ports

in the global buffer pool should be reduced by 64.

Features Not Supported on the Cisco MDS 9148 Switch

The Cisco MDS 9148 Multilayer Fabric Switch does not support the following NX-OS features:

• Remote Span

• Translative loop support

• FCC - no generation, quench reaction only

• FC-Redirect

• DMM

• SME

• IOA

• FCoE

In addition, the following features have these limits:

• VSANs - 31 maximum

• SPAN - 1 session maximum

PPRC Not Supported with FCIP Write Acceleration

IBM Peer to Peer Remote Copy (PPRC) is not supported with FCIP Write Acceleration.

Configuring a Persistent FCID in an IVR Configuration with Brocade Switches

The following information is relevant if you have a fabric that consists of Cisco MDS 9000 switches and

Brocade switches, and the Cisco MDS switches are running either NX-OS Release 4.x or Release 5.x

and Brocade is running FOS higher than 6.x. In an IVR configuration, when IVR NAT is enabled on a

Cisco MDS 9000 switch, the device in the native VSAN should be configured with a persistent FCID.

Assuming the FCID is 0xAABBCC, AA should be configured with the virtual IVR domain ID of the

VSAN that contains the ISLs and BB should be configured in the following range:

• 1 through 64 if the Brocade switch is operating in native interop mode.

• 1 through 30 if the Brocade switch is operating in McData Fabric mode or McData Open Fabric

Mode.

This configuration ensures that the devices connected to the Cisco MDS 9000 switch can be seen in the

name server database on the Brocade switch.