Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-122
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
IKE Messages
This section contains the Internet Key Exchange (IKE) messages.
IKE-3
Error Message IKE-3-CRYPTO_INIT_ERROR: IKEv2 crypto init error: [chars].
Explanation Cryptographic initialization error.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 2.0(1b).
Error Message IKE-3-ENABLE_ERROR: Unable to store enable flag in configuration
(error-id [hex]).
Explanation
The Internet Key Exchange (IKE) service failed to store the enable flag in the
configuration. As a result, IKE will exit.
Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced Cisco MDS SAN-OS Release 2.0(1b).
Error Message IKE-3-FIPS_MODE_ERROR: Could not set FIPS mode.
Explanation
The FIPS mode could not be set by IKE.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 3.1(1).
Error Message IKE-3-MAX_HALF_CONN_LIMIT_REACHED: IKEv1 : Exceeded the limit for
number of half open Phase 1 connections.
Explanation
The number of half open connections has exceeded the maximum limit.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 3.0(3).
Error Message IKE-3-PHASE1_NEGOTIATION_FAILED: IKEv1: Phase 1 negotiation failed
for peer [chars].
Explanation The Internet Key Exchange (IKE) policy negotiation failed for the peer.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 2.0(1b).