Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to mdsfeedback-doc@cisco.com
2-136
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message IPS-3-FCIP_FTA_ERA_35: ERA [hex] presented to CH FCID: [hex] CHI: [hex]
from FCIP CU FCID [hex] CUI: [hex] DA [hex] VSAN: [hex].
Explanation FCIP got an ERA 35.
Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced Cisco MDS SAN-OS Release 3.0(1).
Error Message IPS-3-FCIP_FTA_ERA_38: ERA 0x38 received CH FCID: [hex] CHI: [hex] from
FCIP CU FCID [hex] CUI: [hex] DA [hex] VSAN: [dec] at tape capacity: [dec] MB.
Explanation FCIP got an ERA 38.
Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced Cisco MDS SAN-OS Release 3.1(1).
Error Message IPS-3-FCIP_FTA_LOCATE_RBID_MISMATCH: Permanent Error due to Locate
RBID Mismatch, CH FCID: [hex] CHI: [hex] CU FCID [hex] CUI: [hex] DA [hex] VSAN:
[dec].
Explanation
FCIP-FTA received a permanent error.
Recommended Action This error message is informational. No action is required.
Introduced Cisco MDS SAN-OS Release 3.1(1).
Error Message IPS-3-FCIP_FTA_PERM_ERR: Permanent Error, ERA [hex] rcvd CH FCID:
[hex] CHI: [hex] CU FCID [hex] CUI: [hex] DA [hex] VSAN: [dec] sense_byte[2,6]:
[[hex], [hex]].
Explanation
FCIP-FTA received a permanent error.
Recommended Action This error message is informational. No action is required.
Introduced Cisco MDS SAN-OS Release 3.1(1).
Error Message IPS-3-IPS_CRYPTO_FIPS_FAILED: IPS module [dec] has failed FIPS tests.
FIPS info - [chars].
Explanation
FIPS error occurred in the IPS module.
Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced Cisco MDS SAN-OS Release 3.1(1).