Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-168
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
of sync. with this peer. We recommend that you discard this CFS session using ivr abort command
and then re-enter the configuration changes. You can alternatively use Fabric Manager and/or Device
Manager instead of the command line method.
Recommended Action No action is required.
Error Message IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices.
Explanation
Device failed to program the FC ID rewrite entries; this probably occurred because the
hardware ran out of FC ID rewrite entries. This can happen if there are too many devices in an
inter-VSAN routing (IVR) zone, or there are too many local VSANs in the VSAN topology.
Recommended Action Reduce the number of devices involved in inter-VSAN routing (IVR) in the
active IVR zone set. Also, reduce the number of redundant transit VSANs, if any.
Introduced Cisco MDS SAN-OS Release 2.1(1a).
Error Message IVR-2-DEVICE_ON_WRONG_NATIVE_AFID_VSAN: Device with port WWN [chars]
(FCID:[chars], native VSAN [dec] native AFID [dec]) may not be exported to other
VSANs (for Inter-VSAN zoning) because it has come online in VSAN [dec] AFID [dec].
Explanation
Device has come online on a different AFID/VSAN from the configured native
AFID/VSAN, or the device does not satisfy unique domain criteria.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 2.1(1a).
Error Message IVR-2-DEVICE_ON_WRONG_NATIVE_VSAN: Device with port WWN [chars]
(FCID:[chars], native VSAN [dec]) may not be exported to other VSANs (for
Inter-VSAN zoning) because domain [hex] exists in VSAN [dec].
Explanation
Device has come online on a VSAN different from the configured native VSAN, or the
device does not satisfy unique domain criteria.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message IVR-2-DEVICE_STATE_INCOMPATIBLE_WITH_NAT_MODE: State for device with
port WWN [chars] could not be restored because it was incompatible with the current
NAT mode([dec]). This probably happened because NAT mode was modified without
completely deactivating the active IVR zoneset.
Explanation This can happen if the Network Address Translation (NAT) mode is modified without
completely deactivating the active inter-VSAN routing (IVR) zone set.
Recommended Action Reboot the switch.
Introduced Cisco MDS SAN-OS Release 2.1(1a).