Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to mdsfeedback-doc@cisco.com
2-200
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message MODULE-2-XBAR_SOMEPORTS_FAILED: Xbar [dec] (serial: [chars]) reported
failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec]
(error [hex]).
Explanation
Xbar reported a failure in the runtime diagnostic because of failure in some of the ports.
Recommended Action Collect information about the module by issuing the show module internal
all xbar [decimaldigit] CLI command or by using a similar Fabric Manager procedure.'
Introduced Cisco MDS SAN-OS Release 3.0(1).
Error Message MODULE-2-XBAR_UNKNOWN: Xbar type [[dec]] in slot [dec] is not
supported.
Explanation
The software card ID of xbar is not supported by the supervisor.
Recommended Action Collect information about the module by issuing the show module internal
all xbar [decimaldigit] CLI command or by using a similar Fabric Manager procedure.'
Introduced Cisco MDS SAN-OS Release 3.0(1).
MODULE-3
Error Message MODULE-3-MOD_SRG_NOT_COMPATIBLE: Module [dec] firmware is not
compatible with supervisor, downloading new image.
Explanation The software version of the module is not supported by the supervisor module.
Recommended Action Collect module information by entering the show module internal all module
CLI command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
MODULE-4
Error Message MODULE-4-MOD_WARNING: Module [dec] reported warnings on ports
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device error
[hex]).
Explanation Module reported a warning in the runtime diagnostic because of a failure in some of the
ports.
Recommended Action Collect module information by entering the show module internal all module
CLI command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 1.2(2a).