Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-227
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message PLATFORM-2-PS_UNSUPPORTED: Detected an unsupported power supply [dec]
[chars] for CISCO MDS 9500/9200 Multilayer Switches (Serial number [chars]).
Explanation This power supply is not supported for the Cisco MDS 9500 or 9200 series of switches.
Recommended Action Refer to the appropriate product hardware installation guide for information
on increasing or decreasing power supply capacity and configuring power supplies.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message PLATFORM-2-SYS_IDPROMBAD: Chassis IDPROM [dec] data invalid.
Explanation
The named chassis IDPROM contains invalid data.
Recommended Action Use the show sprom module [decimaldigit] CLI command to read module
IDPROM contents and collect more information. Or, use a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 3.0(1).
Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_FAIL: Chassis IDPROM [dec] data
re-initialization Un-successful. Data is invalid.
Explanation
Chassis IDPROM re-initialization was unsuccessful. The data is invalid.
Recommended Action Us ethe ’show sprom module decimal digit 1 CLI command to read the
module IDPROM contents and collect more information.
Introduced Cisco MDS SAN-OS Release 3.0(2).
Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_PASS: Chassis IDPROM [dec] data
re-initialized successfully.
Explanation
Chassis IDPROM invalid data was succesfully re-initialized to valid.
Recommended Action Us ethe ’show sprom module decimal digit 1 CLI command to read the
module IDPROM contents and verify the information.
Introduced Cisco MDS SAN-OS Release 3.0(2).
PLATFORM-3
Error Message PLATFORM-3-MOD_PWRFAIL: Module [dec] failed to power up (Serial No.
[chars]).
Explanation
The module failed to power up.
Recommended Action Enter the show platform internal all module [dec] CLI command or use a
similar Fabric Manager/Device Manager procedure to collect more information.
Introduced Cisco MDS SAN-OS Release 1.2(2a).