Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-257
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
PORT_CHANNEL Messages
This section contains the PortChannel (PORT_CHANNEL) messages.
PORT_CHANNEL-1
Error Message PORT_CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed
[[chars]].
Explanation
Module configuration failed.
Recommended Action The module is automatically reset. If the problem persists, contact your
customer support representative.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message PORT_CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec]).
Explanation There is not enough memory.
Recommended Action Check if the system is low on memory and reset the switch if necessary.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message PORT_CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for
[chars] [[chars]].
Explanation
Parameter mapping failed.
Recommended Action The specified service is misbehaving. Check its status.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message PORT_CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast [chars]:
[chars].
Explanation
Failed to send a multicast message to all modules, usually because some module went
down.
Recommended Action Enter the show port-channel consistency CLI command or use a similar
Fabric Manager/Device Manager procedure to check consistency.
Introduced Cisco MDS SAN-OS Release 1.2(2a).