Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-434
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
VNI Messages
This section contains the virtual network interface (VNI) messages.
VNI-2
Error Message VNI-2-ALLOC_MEMORY: Memory allocation failed.
Explanation The service failed to allocate a block of dynamic memory.
Recommended Action Check the system memory. If system memory is low, reset the switch.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
VNI-3
Error Message VNI-3-INIT_FAILED: Initialization failed. Component [chars].
Explanation
The service failed to start.The failure occurred while initializing the component shown
in the error message.
Recommended Action Enter the show processes CLI command or use a similar Fabric
Manager/Device Manager procedure to check the status of the other processes. Debug the specified
component.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
VNI-6
Error Message VNI-6-INTERFACE_EVENT: VSAN interface [chars] [chars].
Explanation The specified VSAN Interface had a successful event as shown in the error message.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message VNI-6-STARTING: Virtual Network Interface Manager started.
Explanation
The service has successfully started.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).