Cisco Nexus 5000 Series Switch CLI Software Configuration Guide, NX-OS 4.0(1a)N1 (OL-16597-01, January 2009)
Send feedback to nx5000-docfeedback@cisco.com
19-8
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 19 Configuring SSH and Telnet
Configuring Telnet
To reenable the Telnet server, perform this task:
Starting Telnet Sessions to Remote Devices
Before you start a Telnet session to connect to remote devices, you should do the following:
• Obtain the hostname for the remote device and, if needed, the user name on the remote device.
• Enable the Telnet server on the Nexus 5000 Series switch.
• Enable the Telnet server on the remote device.
To start Telnet sessions to connect to remote devices from your Nexus 5000 Series switch, perform this
task:
The following example shows starting a Telnet session to connect to a remote device:
switch# telnet 10.10.1.1
Trying 10.10.1.1...
Connected to 10.10.1.1.
Escape character is '^]'.
switch login:
Clearing Telnet Sessions
To clear Telnet sessions from the Nexus 5000 Series switch, perform this task:
Command Purpose
switch(config)# telnet server enable
Reenables the Telnet server.
Command Purpose
switch# telnet hostname
Creates a Telnet session to a remote device. The
hostname argument can be an IPv4 address, an IPv6
address, or a device name.
Command Purpose
Step 1
switch# show users
Displays user session information.
Step 2
switch(config)# clear line vty-line
Clears a user Telnet session.