Cisco Nexus 5000 Series Switch CLI Software Configuration Guide, NX-OS 4.0(1a)N1 (OL-16597-01, January 2009)

Send feedback to [e-mail]
24-4
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 24 Configuring Online Diagnostics
Configuring Online Diagnostics
Configuring Online Diagnostics
You can configure the bootup diagnostics to run the complete set of tests, or you can bypass all bootup
diagnostic tests for a faster module boot up time.
Note We recommend that you set the bootup online diagnostics level to complete. We do not recommend
bypassing the bootup online diagnostics.
To configure the bootup online diagnostics level, perform these steps:
The following example shows how to configure the bootup diagnostics level to trigger the complete
diagnostics:
switch# configure terminal
switch(config)# diagnostic bootup level complete
Verifying Online Diagnostics Configuration
To display online diagnostics configuration information, perform one of the following tasks:
Default Settings
Table 24-6 lists the default settings for online diagnostics parameters.
Command Purpose
Step 1
switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# diagnostic bootup level
[complete | bypass]
Configures the bootup diagnostic level to trigger
diagnostics when the device boots, as follows:
• complete—Performs all bootup diagnostics. This
is the default value.
• bypass—Does not perform any bootup
diagnostics.
Step 3
switch# show diagnostic bootup level
(Optional) Displays the bootup diagnostic level
(bypass or complete) that is currently in place on the
switch.
Command Purpose
show diagnostic bootup level Displays the bootup diagnostics level.
show diagnostic result module slot Displays the results of the diagnostics tests.