Cisco Nexus 5000 Series Switch CLI Software Configuration Guide, NX-OS 4.0(1a)N1 (OL-16597-01, January 2009)

Send feedback to [e-mail]
42-3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 42 Discovering SCSI Targets
Displaying SCSI LUN Information
Displaying SCSI LUN Information
Use the show scsi-target and show fcns database commands to display the results of the discovery.
The following example displays the discovered targets:
switch# show scsi-target status
discovery completed
Note This command takes several minutes to complete, especially if the fabric is large or if several devices
are slow to respond.
The following example displays the FCNS database:
switch# show fcns database
The following example displays the SCSI target disks:
switch# show scsi-target disk
The following example displays the discovered LUNs on all operating systems:
switch# show scsi-target lun os all
The following example displays the port WWN that is assigned to each operating system (Windows,
AIX, Solaris, Linux, or HPUX):
switch# show scsi-target pwwn