Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2(1) (OL-16599-01, March 2009)

Send comments to [e-mail]
2-9
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
channel-group (Ethernet)
• Rate mode
• Shutdown
• SNMP trap
If interfaces are configured for the EtherChannel interface and a member port is removed from the
EtherChannel, the configuration of the EtherChannel interface is not propagated to the member ports.
Any configuration changes that you make in any of the compatibility parameters to the EtherChannel
interface are propagated to all interfaces within the same channel group as the EtherChannel (for
example, configuration changes are also propagated to the physical interfaces that are not part of the
EtherChannel but are part of the channel group).
Examples This example shows how to add an interface to LACP channel group 5 in active mode:
switch(config)# interface ethernet 1/1
switch(config-if)# channel-group 5 mode active
Related Commands Command Description
show interface
port-channel
Displays information about the traffic on the specified EtherChannel
interface.
show lacp Displays LACP information.
show port-channel
summary
Displays information on the EtherChannels.