Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2(1) (OL-16599-01, March 2009)

Send comments to [e-mail]
8-107
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
npv traffic-map
npv traffic-map
To configure a N Port Virtualization (NPV) traffic map, use the npv traffic map command. To disable
this feature, use the no form of the command. This command is only available when the switch is
operating in NPV mode.
npv traffic-map server-interface {fc slot/port | vfc vfc-id} external-interface fc slot/port
no npv traffic-map server-interface {fc slot/port | vfc vfc-id} external-interface fc slot/port
Syntax Description
Command Default No traffic map. The switch uses automatic uplink selection to select an NP uplink for the server interface.
Command Modes Configuration mode
Command History
Usage Guidelines NPV traffic maps can be configured only in NPV mode.
Examples The following example creates a mapping between server interface vfc1 and NP uplink fc 3/1:
switch(config)# npv traffic-map server-interface vfc 1 external-interface fc 3/1
Related Commands
server-interface Specifies the server interface or a range of server interfaces.
fc slot/port Specifies the slot number and port number for a native Fibre Channel
interface.
vfc vfc-id Specifies a virtual Fibre Channel interface.
external-interface Specifies the NP uplink interface or a range of NP uplink interfaces that can
be selected by the server interface.
Release Modification
4.0(0)N1(2a) This command was introduced.
Command Description
npv enable Enables NPV mode.
show npv status Displays the NPV current status.