HP Designjet 4520 Printer series - Assembly Instructions: English

37 38 39 40
Locate the pin into the interior of the right leg.Remove the top yellow plug on the left leg. Locate the pin into the interior of the left leg. Remove the top yellow plug on the right leg.
41 42 43 44
Slide Drawer 1 out until it touches the foam
packaging.
You now need to identify the left and right of the
printer. This information is shown on the foam
end packs. Also identify the rear of the printer.
Pull open the protective plastic from the base of
the printer. Please ensure that there is a three-
meter space clear of obstructions to the rear
of the printer and one meter at the front of the
printer.
Remove the two desiccant bags from the printer.
Using the screwdriver supplied, remove the two
screws that hold Drawer 1 in place. Note: the
screws are only for transit, they are not to be
replaced.
Do not replace these
screws after removal!
CM768-900011.indd 6 03/02/2009 17:12:28