Instruction Manual

• To clean contaminants from the optical bores of a CWDM (SFP) transceiver, use lint-free 1.25 m m

Fiber Optic swabs to clean the ferrules of the op tical connector.

• Dispose of this product a ccording to all national laws and regulations.

NOTE:

Dry cleaning is the preferred method. Using alcohol-based cleaning swabs may cause pr oblems.

WARNING!

Fiberopticequipmentcanemitlaserorinfraredlightthatcaninjureyoureyes. Neverlookintoan

optical ﬁberorconnectorport.Alwaysassumethatﬁ ber optic cables are connected to a light source.

Inserting a CWDM (SFP) transceiver

To insert a CWDM (SFP) transceiver:

1. Verify that the CWDM (SFP) transceiver is the correct model for your application.

2. Grasp either side of the CWDM (SFP) transceiver with your thumb and foreﬁnger.

3. Insert the CWDM (SFP) transceiver into the slot on the front panel of the FC or network device

(Figure 12). You should hear a clicking sound when you have properly seated the CW DM (SFP)

transceiver.

Figure 12 Inserting the CWDM transceiver

Removing a CWDM (SFP) transceiver

To remove a CWDM (SFP) transceiver:

1. Discon

nect the ﬁber cable from the CWDM (SFP) transceiver.

2. Lower and pull the bail.

CWDM MUX user guide