User Guide

238 Chapter 6 - Removal and replacement EN

Right covers and doors

Removing the right upper cover assembly

Tray 1 is part of the right upper door. Take the tray off and save it if

you are replacing the whole assembly (see page 261). The new

assembly does not include the tray.

1 Remove the rear cover (see page 243).

2 Open the right upper door.

3 On the right side of the door, unplug four connectors that lead

through the printer frame to the right upper cover (callout 1).

Note Two connectors are plugged into the controller board, and two

connectors are inline connectors. It might be easier to disconnect the

connectors from the rear of the printer and pull the wires through the

printer frame than to unplug the connectors from the right upper door.

Figure 90. Connectors on the right upper door

4 Close the door to a 45-degree angle and release the spring-

loaded hinges on the right side.