User Guide

240 Chapter 6 - Removal and replacement EN
Removing the right cover subassembly
Note Use this procedure if you want to separate the right cover subassembly
from the right upper cover.
1 Open the right upper cover assembly slightly.
2 Pull the right side of the subassembly slightly to the right and pull
outward on the right side to snap it out of place.
3 Move the subassembly slightly to the left and to remove it.
Note There is a small spring on the left side of the subassembly—be careful
it does not fall off.
Notes about reinstalling:
If the spring falls off the subassembly, slide it onto the pin and
through the slot on the left side of the subassembly.
Figure 92. Spring on right cover subassembly