User Guide

EN Rear assemblies 287
Main gear assembly (not shown)
1 Open the left lower cover and remove the fuser.
2 Open the right upper door and remove the transfer drum.
3 Remove the registration roller assembly (see page 263).
4 Remove the paper pick-up assembly (see page 267).
5 Remove the main motor (M4) (see page 281).
6 Remove the lower air duct (see figure 136 on page 285).
7 Remove the lowest gear (callout 1) on the delivery drive assembly
(three screws and one e-ring).
Figure 138. Access to main gear assembly
8 Remove tray 2 and tray 3 from the printer.
9 Remove the tray 2 rail from the front of the printer (one screw, two
connectors).
10 Remove the inner cover 4 (see reference 4, on page 526).
11 Remove the lower (green) lever (two screws).
12 Remove the pressure lever (two e-rings and two bushings).
13 Remove two screws and pull the main gear assembly (callout 2).
2
2
2
1