User Guide

EN Printer message troubleshooting 411
TOP
OUTPUT BIN FULL
Event log message: None
Description:
The top (face-down) output bin of the printer is full.
Action:
1 Remove all media from the top (face-down)
output bin on the printer to continue printing.
2 Verify that PS30, PS10, PS11, and PS3
sensors and the surrounding area are clean.
TRANSFER KIT LOW
REPLACE KIT
Event log message: None
Description:
The transfer drum, transfer belt, cleaning roller, and
charcoal filter are almost past their specified life.
The transfer kit has approximately 750 color or
1,000 black-and-white images remaining until the
printer will signal the end of the kit life.
Action:
Although printing can continue, the transfer kit
should be replaced for optimum printer operation.
Replace the transfer kit and reset the transfer
counter by pressing S
ELECT before attempting to
print (or use the RESETS menu on the printer
control panel).
TRANSFER KIT OUT
REPLACE KIT
Event log message: None
Description:
The transfer drum, transfer belt, cleaning roller, and
charcoal filter are past their specified life. If TONER
LOW is set to continue, printing can continue with
degraded print quality; otherwise printing will be
halted.
Action:
Replace the transfer kit and reset the transfer
counter by pressing S
ELECT before attempting to
print (or use the RESETS menu on the printer
control panel).
For more information about configuring the printer
response to this message, see the description of
the TONER LOW setting on page 88.
TRAY 1 CONTAINS
UNKNOWN MEDIA
Event log message: None
Description:
Media was stacked in tray 1 for continuous manual
feed printing, and the job has been completed.
However, media remains in the input tray. The
printer considers the input tray not to be configured.
Action:
Configure the media type for tray 1 or remove the
remaining media.
For more information about configuring the media
type, see page 104.
Table 42. Unnumbered printer messages (continued)