User Guide

Figure 5-9 Front Cover setting
The Front Cover and Back Cover options are as follows:
●
Add a Blank or Preprinted Cover check box
●
Source is: drop-down menu
●
Type is: drop-down menu
When you select Front Cover or Back Cover, you must also select the Add a Blank or Preprinted
Cover check box to enable the setting. When you select this check box, the Source is: and Type is:
drop-down menus become available and a check mark appears next to the Back Cover option.
NOTE The Back Cover options are not available when the Booklet Layout setting is enabled
on the Finishing tab. For two-page-per-sheet (2-up) booklet printing, you can obtain a cover by
selecting different media for the first page only. The back cover setting is unavailable, because
this page would otherwise be printed in the middle of a booklet.
The Source is: setting specifies the source tray to use for adding a back cover to the document. The
list of source trays depends on the MFP accessories. Any optional media trays that are installed through
the Configure tab also appear here. For more information about the Source is: setting, see the
Source
Is: drop-down menu section of this chapter.
The Type is: drop-down menu shows all of the media types that the MFP supports. For more information
about the Type is: drop-down menu settings, see the
Type is: drop-down menu section of this chapter.
Using the First Page option for the HP Color LaserJet CM1015 MFP/CM1017 MFP
The HP Color LaserJet CM1015 MFP/CM1017 MFP drivers send print jobs in reverse order to
accommodate the face-up output. To compensate for this feature, follow these instructions when using
the First Page option with the Use Different Paper/Covers feature.
1. Click to select theUse Different Paper/Covers check box.
2. Click to select the First Page option.
3. In the Source is: drop-down menu, select Manual Feed in Tray 1.
220 Chapter 5 HP PCL 6 and PS emulation unidrivers for Microsoft Windows ENWW
HP PCL 6 and PS
emulation unidrivers for
Microsoft Windows