User Guide

●
Job Timeout
●
Wait Timeout
●
Minimum font size to download as outline
●
Maximum font size to download as bitmap
Available PostScript Memory
This option specifies the amount of available PS memory. The available PS memory is a subset of the
MFP's total physical memory. It is usually best to use the default setting, which is determined by your
MFP manufacturer.
Output Protocol
This option specifies the protocol that the HP Color LaserJet CM1015 MFP/CM1017 MFP uses for print
jobs. The following options are available.
●
ASCII. (default) When you click ASCII, data is sent in ASCII format (7-bit), which might take longer
to print but can be sent through any I/O channel, such as a USB or network port.
●
TBCP. When you click TBCP (Tagged Binary Communications Protocol), all data except special
control characters is sent in binary (8-bit) format. The binary formats can be sent over USB or serial
communications ports at a faster rate than by sending data in ASCII format.
●
Binary. When you click Binary, all data except special control characters is sent in binary (8-bit)
format. The binary formats can be sent over USB communications ports at a faster rate than by
sending data in ASCII format.
Send CTRL-D Before Each Job
This option specifies whether the HP Color LaserJet CM1015 MFP/CM1017 MFP will be reset at the
beginning of every .PS document. The default setting is No. Ctrl-D resets the MFP to its default setting
to ensure that previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail
if the MFP is connected through a network. If your document fails to print when sent to a MFP connected
through a USB port, change No to Yes.
Send CTRL-D After Each Job
This option specifies whether the HP Color LaserJet CM1015 MFP/CM1017 MFP will be reset at the
end of every .PS document. The default setting is Yes. Ctrl-D resets the MFP to its default setting to
ensure that future print jobs are not affected by the current print job. Ctrl-D might cause a print job to
fail if the MFP is connected through a network. If your document fails to print when sent to a network
MFP, change Yes to No.
Convert Gray Text to PostScript Gray
This option specifies whether to convert the true gray (RGB value) in text to the gray that the
PS Emulation Unidriver provides. The default setting is No.
Convert Gray Graphics to PostScript Gray
This option specifies whether to convert the true gray (RGB value) in graphics to the gray that the
PS Emulation Unidriver provides. The default setting is No.
254 Chapter 5 HP PCL 6 and PS emulation unidrivers for Microsoft Windows ENWW
HP PCL 6 and PS
emulation unidrivers for
Microsoft Windows