User Manual

Set fax send speed
The Fax send speed setting sets the modem bit rate (measured in bits per second) of the Analog Fax
modem while sending a fax.
1. From the Home screen, scroll to and touch the Administration button.
2. Open the following menus:
●
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
3. Touch the drop down menu under the Fax Send Speed heading and then touch one of the
following:
●
Fast (default) — 33600 bps (bits per second)
●
Medium — 14400 bps
●
Slow — 9600 bps
4. Touch the Save button.
Set the redial interval
The redial interval setting selects the number of minutes between retries if the number dialed is busy or
not answering.
NOTE: You might observe a redial message on the control panel when both the Redial-on-Busy
and Redial-on-No-Answer settings are set to off. This occurs when the fax accessory dials a
number, establishes a connection, and then loses the connection. As a result of this error condition, the
fax accessory performs two automatic redial attempts regardless of the redial settings (the first one at
26,400 bps and, if that fails, a second one at 14,400 bps). During this redial operation, a message
appears on the control panel to indicate that a redial is in progress.
1. From the Home screen, scroll to and touch the Administration button.
2. Open the following menus:
●
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
3. Touch the Redial Interval text box to display the keypad.
4. Enter the value (1–5, default is 5) and touch the OK button.
5. Touch the Save button.
214 Chapter 12 Fax ENWW