User Guide

SR14 Fuser Loop 1 and SR15 Fuser Loop 2 sensors
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Slowly insert a piece of paper to activate the fuser loop sensors underneath the fuser.
Figure 2-10 Test the fuser loop sensors
4. Check the control-panel display for a sensor response.
TIP: A green virtual LED displays on the control panel when the sensor is active. The number of
times the sensor is triggered also displays.
5. If there is no response, replace the fuser.
112 Chapter 2 Solve problems ENWW