User Guide

SR13 Tray 2 sensor
1. Remove Tray 2.
NOTE: The Tray 2 sensor flag is on the back of Tray 2. Inspect the flag to verify that it is aligned
correctly. If it is bent upward, it might miss the sensor when installed.
Figure 2-21 Test the Tray 2 sensor (1 of 2)
2. Insert a piece of paper in the Tray 2 sensor.
Figure 2-22 Test the Tray 2 sensor (2 of 2)
3. Check the control-panel display for sensor response.
TIP: A green virtual LED displays on the control panel when the sensor is active. The number of
times the sensor is triggered also displays.
4. If there is no response, replace the lifter-drive assembly.
ENWW
Tools for troubleshooting
125