User Guide

Recommended action
59.05.06 or 59.05.07
1. Turn the product off, and then on.
2. Check the connector (J121) on the DC controller PCA.
3. Use the motor drive test in the component tests to verify that the motor is properly functioning. If it
is not, replace the drum motor (M3).
59.05.08 or 59.05.09
1. Turn the product off, and then on.
2. Check the connector (J120) on the DC controller PCA.
3. Use the motor drive test in the component tests to verify that the motor is properly functioning. If it
is not, replace the drum motor (M1).
59.05.10 or 59.05.11
1. Turn the product off, and then on.
2. Check the connector (J120) on the DC controller PCA.
3. Use the motor drive test in the component tests to verify that the motor is properly functioning. If it
is not, replace the drum motor (M1).
59.05.12 or 59.05.13
1. Turn the product off, and then on.
2. Check the connector (J120) on the DC controller PCA.
3. Use the motor drive test in the component tests to verify that the motor is properly functioning. If it
is not, developing disengagement motor (M10).
4. Use the manual sensor test to verify that the ITB alienation sensor (SR17) is properly functioning. If
it is not, replace the ITB alienation sensor (SR17).
59.05.B0
1. Turn the product off, and then on.
2. Check the connector (J89) on the residual feed motor (M12), intermediate connectors (J75 and
J77), and the connector (J137) on the DC controller.
3. Use the motor drive test in the component tests to verify that the motor is properly functioning. If it
is not, residual feed motor (M12).
4. Use the manual sensor test to verify that the ITB alienation sensor (SR17) is properly functioning. If
it is not, replace the ITB alienation sensor (SR17).
ENWW
Tools for troubleshooting
295