User Guide

Table 2-47 Causes and solutions for pickup delay and pickup stationary jams (continued)
Cause Solution
Multiple feed of paper. If the Tray 3 pickup roller, separation roller or feed roller is worn or deformed,
replace any defective parts.
The Tray 3 feed sensor (SR4) lever is set
incorrectly or damaged.
Check the sensor lever to make sure it is set correctly. If it is damaged, replace
the paper-feeder assembly.
The spring of the Tray 3 feed sensor (SR4)
lever is unhooked.
Check the spring and place it in correct position.
Poor contact of the Tray 3 feed sensor (SR4)
connector.
Reconnect the connector (J405) on the paper feeder driver PCA intermediate
connector (J13) and connector (J20) of the Tray 3 feed sensor.
The Tray 3 feed sensor (SR4) is defective. Run a sensor test to verify that the Tray 3 feed sensor is functioning properly. If
it is not, replace the paper-feeder assembly.
ENWW
Clear jams
389