User Guide

c. Gently tap the ITB on the table ten times.
NOTE: This causes waste toner in the ITB to collect around the auger in the cleaning
section. This waste toner is removed when the ITB is reinstalled.
Figure A-2 Prepare the product for shipping (2 of 3)
d. Reinstall the ITB, and then close the right and front doors to initialize the product. After about
35 seconds, the message Install supplies will appear on the control-panel display.
Perform the following steps two times.
1. Open and then close the front door.
2. The product initializes. Wait about 35 seconds until the message Install supplies will
appear on the control-panel display.
4. Turn the product power off.
5. Wait for 30 seconds after the control-panel display is blank (no longer illuminated), and then
unplug the power cord from the wall receptacle.
CAUTION: Failure to follow this step can result in damage to the fuser or the ITB.
6. Disconnect the interface cables and power cord from the product.
ENWW
Repack the product
451