DisplayMaker Legacy X-12+ - User Manual

4-22 Calibration Summary
Sabre Angle — Troubleshooting data for MacDermid Col-
orSpan Technical Services.
Shown Hidden
Head-to-Head Registration — OK indicates that the
printhead was successfully registered relative to the other
printheads; if not, the amount of error in pixels is shown.
Shown Hidden if no errors found,
Shown if offset errors present
Bidirectional Registration — OK indicates the printhead
was successfully registered in both X (horizontal) direc-
tions; if not, the amount of error in pixels is shown.
Shown Hidden if no errors found,
Shown if bidi errors present
AutoJet Registration — OK indicates that AutoJet was
successful; otherwise, a reference number appears and a
corresponding error message is printed under the header.
Shown Hidden if no errors found,
Shown if errors present.
Jets Disqualified by AutoJet — Number of jets that Auto-
Jet determined must be substituted by other working
jets.
Shown Hidden if no errors found,
Shown if errors present.
Jets Out for X Offset — Number of jets that are out of
registration in the X (horizontal) direction.
Shown Hidden if no errors found,
Shown if errors present.
Jets Out for Y Offset — Number of jets that are out of
registration in the Y (vertical) direction.
Shown Hidden if no errors found,
Shown if errors present.
Jets Unfixed — Shows the print mode and the number of
unfixed jets on each printhead. This number should be
zero for all printheads; more substitute jets are available
with a higher number of print passes.
Shown Shown
Description Show Details Version Hide Details Version