DisplayMaker Legacy X-12+ - User Manual

4-28 Head Height Calibration
A message appears warning you to unload media. The first
part of the calibration sets the head height relative to the
platen without media present.
If media is installed, remove or cut the media from the
takeup, then back up the media using the C key on the con-
trol panel.
WARNING
Keep the printer cover closed during this procedure.
The platen moves out of the service station to the
access position quickly, without further warning.
Operator injury or damage to the carriage could
occur if the carriage movement is blocked.
7. Press B to continue.
The control panel displays a series of messages as the car-
riage is raised and moved to the carriage access position on
the platen.
The control panel displays a message asking you to place
one sheet of copier paper under the right side of the car-
riage, and another sheet of copier paper under the left side
of the carriage. Use standard 20 lb. copier paper. One letter-
size sheet cut in half to make two 8-1/2 x 5-1/2 inch sheets
works well for this purpose.
8. Place sheets of copier paper under the carriage as specified
by the control panel, and press B to continue.
The control panel displays the C and p (Up/Down) keys
and this message:
Use the arrow keys to carefully move the entire carriage
up/down until one side or the other is LIGHTLY resting
on the paper. Press Proceed when ready to level the
carriage.
9. Press the p key to move the carriage down, and move the
right and left sheets of paper repeatedly, until you feel resis-
tance from the carriage touching the paper on either side of
the carriage.
If the carriage is so low that you cannot move the paper at
all, press the C and p keys to raise or lower the carriage
until you can move the paper, yet still feel some resistance.
10. Press the B key.
The control panel displays two sets of C and p keys, one
for the right and one for the left side of the carriage.