DisplayMaker Legacy X-12+ - User Manual

3-28 Loading Media
8. On the Front Page screen of the control panel, press the Load
Media key.
The control panel prompts you to press the B key to load
media, or n to cancel.
9. Press the B key to proceed.
The control panel prompts you to advance the media.
10. Press the p key to advance the media past the front edge of
the platen.
11 . Pr e s s t h e B key to proceed.
12. Select a media thickness from the list.
You can select a ColorSpan media from the list, or select
Custom (at the end of the list) to specify a custom thick-
ness.
If Media Wizard values are present for the media you
selected, the control panel displays this message:
USE MEDIA WIZARD VALUES?
followed by the current settings for platen vacuum, head
height, and 1-pass coverage.
13 . P r e s s
n to use the setting values you entered, or B to ignore
The control panel displays a numeric keypad.
14. Enter the length of the media roll (if it is a new roll) or the
length remaining (if it is a partially used roll), and press the
Enter key to continue.
Fig. 3-14. Numeric entry screen