DisplayMaker Legacy 72UVR, 72UVX, 98UVX Site Preparation Guide Part number 0706274 Rev G 1
Legal notices © Copyright 2008 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
Preparing for Your New Printer Follow these guidelines to prepare your site for delivery of the printer. ◆ A technical representative will work with you prior to installation to prepare your site to receive and install the printer. ◆ Refer to the printer’s User Manual for detailed unpacking and assembly instructions, and parts list.
Space Requirements Allow enough space around the front, rear, and sides of the printer to load and unload ink and media, and operate the control panel at the front of the printer. The exact space required depends in part on whether you will have rigid media tables installed. For further details, see the diagrams below and the dimensions shown in Table 2, “Specifications,” on page 5.
Safety Information ◆ UV light — the ultraviolet (UV) curing lamps emit high power UV light. The printer must be operated with all safety shielding installed to protect the operator from eye and skin damage. When operated according to manufacturer’s instructions, safety glasses or other protective clothing are not necessary. ◆ Ozone — the high power UV light emitted by the curing lamps reacts with oxygen and produces ozone. This formation tends to be greatest during lamp start-up.
Table 2: Specifications Dimensions (Assembled) DisplayMaker 72UVR, DisplayMaker 72UVX Height: 52.5 inches (133.4 cm) Depth without tables: 33.0 inches (83.8 cm) Depth with tables: 87.7 inches (222.8 cm) Width: 133.0 inches (337.8 cm) DisplayMaker 98UVX Height: 52.5 inches (133.4 cm) Depth without tables: 33.0 inches (83.8 cm) Depth with tables: 87.7 inches (222.8 cm) Width: 159.
Table 2: Specifications If your facility power is unstable: The printer requires a stable power supply to ensure acceptable output and sufficient voltage to light the UV lamps. If the voltage supplied to the printer drops significantly during the day due to local or regional power demands or issues, the printer will be unable to perform to specifications. This is an uncommon situation in the United States.
Table 2: Specifications Required power cord (supplied with printer): ◆ Part No. 0501506 North America (UL/CSA approved), length 8.2 feet (2.5 m), OR ◆ Part No. 0602360 Europe (Harmonized), length 8.2 feet (2.5 m) Optional auxiliary power for vacuum system: Supplied 24 volt DC power supply with universal adapters, connected from the 24 VDC jack on the vacuum/pressure assembly to either of two options: 1.
-8- DisplayMaker Site Preparation Guide
