SAN Switch Rack Mount Kit - Installation Instructions

16 SAN Switch Rack Mount Kit Installation Instructions
a. Assemble the two inner rails (one on each side) to the switch using the
appropriate number (from step 5) of #8-32 x 3/16-inch Phillips pan-head
screws as shown in Figure 7.
Note: The rail kit provides fourteen #8-32 x 3/16-inch screws for assembling the inner
rails. Each switch requires a different number of these screws. For example, Figure 7
shows the an inner rail being attached to the SAN Switch 2/16 with five screws.
Attaching both inner rails requires ten screws.
Figure 7: Assembling the inner rails
Note: For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head
screw with thread lock and torque between 6 to 8 inch-pounds.