Compaq ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide

Setting Up Your ProLiant Cluster HA/F500
ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide 2-7
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: 49er Part Number: 268374-002 Last Saved On: 5/28/02 3:01 PM
Zoning
Figure 2-2 shows a cluster cross cable zoning configuration setup.
Host A
Interconnect
LAN
FCA
SA
Top FC Switch
HSV Controller AFP1
FP1
FP2
FP2
HSV Controller B
Storage
Subsystem
Bottom FC Switch
S1 S2 S1 S2
FCA FCA FCA
Host B
Zoning
Top FC Switch
"Controllerzone"
SA
HSV Controller A FP1
HSV Controller B FP2
"Clusterzone"
Host A S1
Host B S1
HSV Controller A FP1
HSV Controller B FP2
Zoning
Bottom FC Switch
"Clusterzone"
Host A S2
Host B S2
HSV Controller B FP1
HSV Controller B FP2
Figure 2-2: Zoning diagram
Use the following steps and Telnet commands to create a controller zone, cluster
zones, and a configuration zone. The SAN switch has a graphical user interface
(GUI) that can also be used to create zoning. Refer to the switch documentation for
detailed information on using the GUI.
1. Telnet to the IP address of one of the switches.