HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Enhanced DT Supplement Guide

Cluster Installation
Figure 2-5: Initialize an HSV Storage System window
5. In the Step 1: Enter a Name field, enter the site name.
6. In the Step 2: Enter the number of disks field, enter the maximum number of
disks (minimum of eight in a disk group) or the number of disks you will use in
the default disk group.
NOTE: You must determine if you will configure your storage in a single disk group or multiple
disk groups.
CAUTION: Do not use the browser Back button because you will undo the previous
operation.
7. Click Finish, and then click OK (if the operation was successful).
NOTE: If the operation is not successful, it typically is caused by a communication problem.
Verify the SAN connection, fix the problem, and begin again at step 1.
2-16 HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Enhanced DT Supplement Guide
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2 Cluster Installation
Codename: 49ers III Part Number: 339223-001 Last Saved On: 5/29/03 2:22 PM