HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide

Setting Up Your ProLiant Cluster HA/F500
e. Select the correct Prefer path/mode. Path A-Failover only or
Path B-Failover only are the only options supported for clustering. Set a
preferred controller for each virtual disk drive, Path A or Path B, for load
balancing.
Figure 2-16: Selecting the preferred path
f. Click Finish, OK.
g. Repeat steps a through f to create the virtual disks needed based on the
number of logical units you will have.
HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide 2-23
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2
Codename: Part Number: 323454-001 Last Saved On: 3/20/03 10:51 AM