HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide

Cluster Installation
Installing the Hardware
The following sections provide information on installing the hardware components
used in a HP ProLiant HA/F500 Enhanced DT cluster.
Setting Up the Servers
To prepare the DRM solution for setup, refer to the Data Replication Manager
HSG80 ACS operations guide for installation information.
Follow the installation instructions in the ProLiant server documentation to set up
each server as a stand-alone server, and then follow the instructions in the following
sections to configure the cluster.
Setting Up the Storage Subsystem
Refer to the documentation that was shipped with the storage subsystem for detailed
installation instructions.
Setting up the Host Bus Adapters (HBAs)
Install two HBAs into the host server to run the DRM solution. Refer to the host bus
adapter guide for detailed information on this hardware.
Locate and record the World Wide Name (WWN) of each HBA. You will need this
number when renaming the host connections later in the installation process.
NOTE: The WWN can be found on the bottom of the HBA board. Look for a small bar code
with an Institute of Electrical and Electronics Engineers (IEEE) precursor. WWN example:
1000-0000-C920-A5BA.
HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide 2-3
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2 Cluster Installation
Codename: Chargers II Part Number: 324547-001 Last Saved On: 4/7/03 10:32 AM