HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide

Cluster Installation
Designating the Server as a Maintenance Terminal
Connect a server to the storage controller to designate a maintenance terminal (refer
to Figure 2-1).
NOTE: Designate only one server as the maintenance server.
To connect the server to the storage controller:
1. Connect the RJ-12 connector (1) on the communications cable to the
maintenance port on the storage controller.
2. Connect the 9-pin serial connector (2) on the communications cable to either the
COM1 or COM2 port on the server.
NOTE: Note which serial port you use. You will need this information when setting up the
communications program and configuring the controller.
Figure 2-1: Designating a maintenance terminal
2-4 HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2 Cluster Installation
Codename: Chargers II Part Number: 324547-001 Last Saved On: 4/7/03 10:32 AM