HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide

Cluster Installation
2. The following CLI command creates remote copy sets. When this command is
entered, the controllers copy all data from the initiator unit to the target unit. This
process is called normalization.
Create the remote copy sets by entering the following command:
ADD REMOTE RemoteCopySetName InitiatorUnitName
RemoteNodeName\TargetUnitName
Example: ADD REMOTE RC_D1 D1 SITEBA\D1
NOTE: It is not necessary to repeat this step at the target site.
A %EVL message is displayed that includes the remote copy set information.
The display will be similar to Figure 2-25.
%EVL--Initra >--13-JAN-1946 05:01:56(time not set)--Instance Code:0E010064
Template: 144.(90)
Power On Time: 0. Years, 36. Days, 6. Hours, 45. Minutes, 22. Seconds
Controller Model: HSG80
Serial Number: ZG8nnnnnnn
Hardware Version: Enn(2B)
Software Version: V85P
Informational Report
Target Controller Board Serial Number: " ZG8nnnnnnn"
Initiator WWLID: nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn
Initiator Node Name: SiteA
Initiator Unit Number: n.(nnnnnnnn)
Target WWLID: nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn
Target Node Name: SiteB
Target Unit Number: n.(nnnnnnnn)
Number of Targets: n.(nnnnnnnn)
Remote Copy Set Name: "RMT0"
Instance Code: 0E010064
Figure 2-25: Creating a remote copy set
Creating Log Units and Association Sets (Optional)
In the following example, hypothetical disks 50100 and 60100 are used as the
mirrorset for the log disk. The log unit is D10. The association set name is AS_D1.
The association set is using remote copy set name RC_D1.
HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide 2-37
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2 Cluster Installation
Codename: Chargers II Part Number: 324547-001 Last Saved On: 4/7/03 10:32 AM