HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide

Cluster Installation
8. “Creating Log Units and Association Sets” (optional)
9. “Enabling Access to the Host at the Initiator Site”
Adding Clusters
The HA/F500 Enhanced DT cluster supports up to four clusters per set of four Fibre
Channel switches, with one cluster node in each of the two locations.
NOTE: Sufficient storage space must be available to add clusters.
Each of the clusters can access storagesets consisting of disks in the existing storage
subsystems. Although the different clusters can access a common set of storage
subsystems, they cannot access the same storagesets within the storage systems.
Access to each of the storagesets is enabled only for the cluster nodes for that cluster.
Each cluster has exclusive access to its own storagesets but does not have access to
storagesets belonging to the other clusters.
Because the storage subsystems have already been installed, all that remains is to
install the additional servers and granting them access to their storagesets.
It is assumed that all of the storagesets, LUNs, and remote copy sets for this cluster
have already been created.
NOTE: Refer to the StorageWorks HSG80 Array Controller ACS CLI reference guide for
configuration information.
2-54 HP ProLiant Cluster HA/F500 for MA8000 Enhanced DT Supplement Guide
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2 Cluster Installation
Codename: Chargers II Part Number: 324547-001 Last Saved On: 4/7/03 10:32 AM