HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide

Setting Up Your ProLiant Cluster HA/F500
Enterprise Virtual Array
Refer to the Enterprise Virtual Array hardware documentation for detailed
installation and setup instructions. Install the following:
•
•
•
Rack, drive enclosures, disk drives, and associated firmware
Environmental Monitoring Unit
HSV controllers
HP OpenView Storage Storage Management Appliance
Refer to the management appliance documentation for detailed setup and
configuration instructions. Perform the following tasks:
1. Set up the management appliance.
2. Install the HSV Element Manager software.
ProLiant Servers
Refer to your server documentation and FCA documentation for detailed installation
instructions. Perform the following tasks:
1. Install the following hardware in the servers:
a. FCAs
The FCA board plugs into a standard PCI slot in the host computer. Refer to
the system manual for instructions on plugging in boards.
IMPORTANT: Record the FCA ID (12-digit IEEE address) and the server and adapter
slot in which the adapter is installed. This information will be needed when configuring
switch zoning and when creating the storage system and virtual disks. Use the worksheet
in Appendix A to record the information.
b. NICs
2. Cable the fiber connections to the servers, storage, and the management
appliance.
2-2 HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2
Codename: Part Number: 323454-001 Last Saved On: 3/20/03 10:51 AM