HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide

Setting Up Your ProLiant Cluster HA/F500
Verifying FCA Firmware
Verify that the FCA cards have the correct firmware. Run lputilnt, which is found in
WINNT\System32\.
Zoning
Figure 2-1 shows a cluster cross-cable zoning configuration setup.
Figure 2-1: Zoning diagram
Use the following steps and Telnet commands to create a controller zone, cluster
zones, and a configuration zone. The SAN switch has a graphical user interface
(GUI) that can also be used to create zoning. Refer to the switch documentation for
detailed information on using the GUI.
1. Telnet to the IP address of one of the switches.
2-6 HP ProLiant Cluster HA/F500 for Enterprise Virtual Array Setup and Installation Guide
HP CONFIDENTIAL
Writer: Bill Akers File Name: c-ch2
Codename: Part Number: 323454-001 Last Saved On: 3/20/03 10:51 AM