Clustering setup and installation guide

Cluster Setup and Installation
Compaq Smart Array Cluster Storage Clustering Setup and Installation Guide 2-5
COMPAQ CONFIDENTIAL
Writer: John Turner File Name: c-ch2 cluster setup and installation.doc
Codename: Voyager CL+ Part Number: 272402-001 Last Saved On: 1/3/02 9:18 AM
d. Connect peripheral devices, such as the keyboard, mouse, and monitor.
NOTE: If you are using a KVM (keyboard, video, mouse) switchbox, refer to the
switchbox documentation for detailed instructions. Compaq recommends that you use a
KVM switchbox with the cluster.
e. Connect the power cords.
NOTE: Compaq recommends that you use an uninterruptible power supply (UPS) to
allow for the proper shutdown of the cluster in the event of a power loss. For more
information about UPS units, see the “Uninterruptible Power Supply” section.
8. If your system is already configured for clustering, go directly to step 9 to use
your cluster.
If your system is not configured, go to Chapter 3 in this guide for instructions to
configure your cluster.