Clustering setup and installation guide

System Setup and Configuration
3-2 Compaq Smart Array Cluster Storage Clustering Setup and Installation Guide
COMPAQ CONFIDENTIAL
Writer: John Turner File Name: d-ch3 system setup and configuration.doc
Codename: Voyager CL+ Part Number: 272402-001 Last Saved On: 1/3/02 10:59 AM
Configuring the Servers
1. Power up one of the servers, either or .
IMPORTANT: Do not power up the storage system at this time.
1
2
3
Figure 3-1: Storage and server power buttons
A message is displayed that reads as follows:
Slot 0 – Compaq Smart Array xxxx controller
1775 – Slot 0 drive array – ProLiant Storage Enclosure
not responding.
SCSI port 1: Check storage enclosure power switch and
cables. Turn system power OFF while checking ProLiant
power and cable connections, then turn system power back
ON to retry.
2. Ignore the message in this case. Press the F1 key to clear the message from
the screen.