Clustering setup and installation guide

System Setup and Configuration
3-4 Compaq Smart Array Cluster Storage Clustering Setup and Installation Guide
COMPAQ CONFIDENTIAL
Writer: John Turner File Name: d-ch3 system setup and configuration.doc
Codename: Voyager CL+ Part Number: 272402-001 Last Saved On: 1/3/02 10:59 AM
Configuring the Storage System
To configure the storage system:
1. Power down the servers.
2. Power up the cluster as follows:
a. Power up the storage system
.
IMPORTANT: You must power up the cluster storage system before powering up the
servers. After powering up the cluster storage system, wait until a message is displayed
indicating that the storage system startup is complete before powering up the servers. It
might take up to two minutes for the storage system to completely power up.
b. Power up the servers and log on to each server individually , .
1
2
3
Figure 3-2: Storage and server power buttons
3. The procedure for this step depends on your operating system, as follows: