Compaq Factory-Installed Operating System Software for Microsoft Windows 2000 Advanced Server on ProLiant CL380 Servers Installation Guide

Compaq Factory-Installed Software for Windows 2000 Advanced Server on ProLiant CL380 Servers 19
Compaq Confidential – Need to Know Required
Writer: Michele Richardson Project: Compaq Factory-Installed Software for Windows 2000 Advanced Server on ProLiant CL380 Servers Comments:
Part Number: 191234-003 File Name: 192134-003.doc Last Saved On: 3/12/01 11:25 AM
To install Active Directory support, click Configure Your Server,
which is found under Administrator Tools. Launch the Active
Directory Wizard from the Configure Your Server panel. Follow the
prompts to complete the installation.
NOTE: If Server Node 1 will not be a domain controller, then it must be a stand-alone
server joined to a domain controller. If Server Node 1 is a stand-alone server, proceed to
step 6.
Refer to the Microsoft Windows 2000 Advanced Server documentation
for details on installing and configuring the Active Directory Services.
5. Close all applications, reboot the server, and log on.
6. At the Configure Your Server screen, click Advanced.
7. Page down and select Set Up Cluster Service to start the Cluster
Service Configuration Wizard. Follow the on-screen prompts to
complete the installation.
NOTE: Refer to the operating system online help or the Microsoft Windows 2000
A
dvanced Server documentation for more information on installing and configuring Cluster
Service.
Server Node 1 installation is complete. Leave Server Node 1 powered
up while installing Server Node 2.
Installing Server Node 2
Complete the installation of the factory-installed operating system and
configure Server Node 2 by following the procedures in the sections
“Installing Server Node 1” and “Post-Installation Tasks,” substituting
Server Node 2 for Server Node 1 in all procedures.
NOTE: The shared storage will already be powered up when installing Server Node 2.
Disregard this instruction in step 1 of the procedure.