Compaq ProLiant CL380 Software User Guide

2-6 Compaq ProLiant CL380 Software User Guide
Compaq Confidential – Need to Know Required
Writer: Linda Arnold Project: Compaq ProLiant CL380 Software User Guide Comments:
Part Number: 157839-004 File Name: c-ch2 System Setup and Configuration for Microsoft Windows 2000 Advanced Server.doc Last Saved
On: 12/14/00 8:48 AM
4. Press Print Screen to access the KVM switch and choose server node 2
from the list.
NOTE: For detailed instructions on using the KVM switch, refer to the
Compaq ProLiant CL380 User Guide.
5. Install and configure the Cluster Service component on node 2.
NOTE: Refer to the Microsoft Windows 2000 Advanced Server documentation for details
on installing and configuring Cluster Service.
6. Optionally, install the latest operating system service pack and restart
the system.
7. If you elected to install the latest operating system service pack, run the
Compaq Support Paq for Windows 2000 to ensure that the latest
Compaq drivers have not been overwritten during the installation of the
service pack.
The ProLiant CL380 is now configured and ready for use. To verify the
configuration, see “Verifying Creation of the Cluster” in this chapter.
Manual Installation Using SmartStart
Performing a manual installation with SmartStart minimizes SmartStart’s
involvement. The manual installation routine runs the Compaq System
Configuration Utility. When you are prompted for the Microsoft
Windows 2000 Advanced Server CD, SmartStart transfers the installation
procedure to Windows 2000 Advanced Server. Follow the instructions on the
Windows 2000 Advanced Server installation screens.
To manually install the cluster software using SmartStart, you need the
following:
■ Compaq SmartStart and Support Software CD 4.90 or later
■ Compaq Management CD 4.90 or later
■ SmartStart Installation Poster
■ Microsoft Windows 2000 Advanced Server
Configuring the Server Nodes
1. Apply power to the shared storage area and boot server node 1 from the
SmartStart and Support Software CD.