Compaq ProLiant CL380 User Guide

4-68 Compaq ProLiant CL380 User Guide
Compaq Confidential – Need to Know Required
Writer: Marcello Frau Project: Compaq ProLiant CL380 User Guide Comments:
Part Number: 118128-003 File Name: e-ch4 Installing Hardware Options.doc Last Saved On: 8/28/00 4:41 PM
10. Connect the CD-ROM cable to the rear of the CD-ROM drive.
Figure 4-73. Connecting CD-ROM cable
11. Replace the 1.44-MB diskette drive.
12. Replace the server node in the system.
NOTE: For detailed instructions on replacing a server node, see the “Replacing a Server
Node” section earlier in this chapter.
13. Reconfigure the system. For more information on reconfiguring your
system, refer to the Compaq ProLiant CL380 Software User Guide.
The 2 x 1-inch drive cage option is now installed in your server. Install
Ultra2
or Ultra3
SCSI hard drives in the drive cage, and restore data from your data
backup onto the new drives, as needed.
NOTE: When combining Ultra2 and Ultra3 hard drives, all of the drives are limited to
response times no faster than the maximum burst rate of up to 80 MB/s on the Ultra2
SCSI bus, or the transfer rate of the slowest device in the array.