Hardware Reference Manual

(2) Ethernet RJ-45 connector (6) Monitor connector
(3) Parallel connector (7) Serial connector
(4) Universal serial bus (USB) connectors (4) (8) Power connector
For more information, see the model-specific QuickSpecs at http://h18004.www1.hp.com/products/quickspecs/
QuickSpecs_Archives/QuickSpecs_Archives.html
Installing the stand
To install the stand:
1. Turn unit upside down.
2. Locate the slots on the bottom of the unit into which the tabs on the stand fit.
3. Insert the tabs into the slots (1), and then slide the stand about 1/2–inch toward the back of the
unit until it locks into place (2).
Figure 1-4 Installing the stand
Removing the stand
To remove the stand:
1. Turn unit upside down.
ENWW Installing the stand 3